Water
or oil temp sender, high match 140-280F, w/sealed plug wire harness.
The harness is 10′ (120″ or 3.05 meter) long, UL approved cable.
Temp
range: 140 – 280F, high match, normally used in oil (transmission) temp.
Output
(connect to gauge): 240 – 33 ohms, Stewart-Warner standard.
1/8″-27
NPT thread mounting, 1/2″ long for thread portion. See our fitting set for other thread size below.
Weather
pack sealed quick disconnect, wire harness included.
3/4″
hex size.
0.9” long
probe, can be cut to 0.55” probe length, there is a cutting gap on the probe
for easy cutting.
Total 1.3″
long below hex head without cutting.
Wiring: red for signal, black for ground. Black wire also can be connected to chassis for grounding.
For matching gauges, see below link:
stores.ebay.com/industrialstuffs/1921055017
stores.ebay.com/industrialstuffs/16612838017
For different thread size, 1/4″, 3/8″, 1/2″ NPT, see blow:
www.ebay.com/itm/-/272326336606
We will give you $5.00 refund if you buy the above fitting set.
For other temp senders, see:
stores.ebay.com/Industrialstuffs/4491721017